Westinghouse 7041200 Manuál s instrukcemi stáhnout pdf

70412

To be installed and/or used in accordance with appropriate electrical

codes and regulations.

WARNING: To avoid fire, shock, or death, unplug lamp or turn off

power at circuit breaker or fuse and test that power is off before

wiring.

To Install:

(For use with #18 or #16 AWG Stranded Copper Wire Only)

1. To disassemble shell from cap, press where indicated on shell.

Remove wires from interior mechanism, and loosen set screw (if any)

on bushing of old cap. Unscrew cap from pipe while holding pipe to

prevent it from turning.

2. Pass wire through bushing on new cap. Screw cap onto pipe. If

applicable, tighten set screw on cap bushing securely. Insulating disk

must be in bottom of cap.

3. Tie underwriters knot in wires (see diagram). Pull knot tight.

4. Strip insulation to expose

⁄

” to

⁄

” of bare copper strands. Be careful

not to damage wire strands or insulation beyond stripped length.

5. Twist copper strands of each wire tightly together. Loop wires clockwise

⁄

turn around terminal screws. Firmly tighten screws over wire loops.

Connect white or ribbed wire (or with color tracer or with silver strands)

to silver terminal screw and remaining wire to brass terminal screw. Cut

off any loose strands not secure under screw heads.

6. Slide metal shell (with insulating liner inside) over mechanism so switch

is seated in slot(s) on shell and push shell firmly into cap until it locks

securely and evenly into position. To assure locking, push on metal

shell only. Pushing on inner liner may prevent locking.

7. Plug in lamp or restore power.

8. Follow these instructions exactly to maintain the polarity of a correctly

wired system.

Underwriter's Knot

Nudo "Underwriter's"

Tighten

Terminal Screw

Apretar el Tornillo

de la Terminal

Brass Finish

Acabado

Latón

Rated: 250W-250V • Standard Base

Complete Spanish instructions

are enclosed.

Instrucciones de instalción incluides

en Español.

Brass Finish 1
Acabado 1

Shrnutí obsahu

Strany 1 - Acabado

70412To be installed and/or used in accordance with appropriate electrical codes and regulations. WARNING: To avoid fire, shock, or death, unplug lamp

Komentáře k této Příručce

Žádné komentáře

Westinghouse 7041200 Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro ne Westinghouse 7041200. Westinghouse 7041200 Instructions / Assembly Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro ne Westinghouse 7041200